Automatic Test Equipment (ATE)

    INCOM Tester

    brazilian hair uk
  • Functional Tester for INCOM System of LCA, Su30 & Jaguar
  • On board RF Signal Generator , RF Signal Analyser, Audio Signal Analyser / Signal Generator, Modular Measuring instruments, RF switch
  • Frequency Range : 100MHz – 500 MHz
  • Parameters tested - Frequency Error, Carrier Power, Power Consumption, Modulation Depth, Modulation Distortion, Incidental AM/FM, Side tone Output, Side tone Distortion, Modulation Response, Side tone Response, CNR, Harmonic/Spurious Rejection etc

  • RF Hardware Capability - Generator / Analyzer
  • RF Frequency range - 108MHz to 399.975MHz
  • RF Amplitude - -120dBm to +10dBm
  • Input / Output impedance - 50ohm.
  • Real time bandwidth - 20MHz
  • No of RF channel (Input) - 1
  • No of RF channel (output) - 1
  • Audio Frequency range - 300Hz to 3KHz
  • Audio Signal Amplitude - 250mV to 500mV (rms)
  • No of Audio channel (Input) - 2
  • No of Audio channel (output)- 2
  • Modes Supported - Auto & Manual
  • Communication Protocol - MIL-STD-1553B
  • UUT Test Capability - 1210A (MBU), 1210AL,(LCA), 1215A (SU 30)

    Brake Hydraulics Engine & Electrical Monitoring Unit (BHEEM) - ATE

  • Real-time PXI based ATE & simulator with necessary Interface Modules and signal conditioning cards
  • Simulates various systems monitored and controlled by BHEEM-EU - Brake Management system, Under-Carriage System, Nose Wheel Steering system, Hydraulic Power supplies and distributions System, Electrical Monitoring System, Engine Monitoring and BC Simulator and EFI Monitor
  • Communicates to UUT thro EFI Monitor (RS-422), BC Simulator (MIL-STD-1553B)

    RF ATE

  • Compact On board RF Signal Generator, RF Signal Analyser, Modular Measuring instruments, RF switch
  • Functional testing of Stand alone RF UUT - Transmitters / Receivers
  • Analog Modulation schemes (AM, FM & PM), Digital Modulation schemes (ASK, FSK, PSK & QAM), Frequency Sweep, Power Sweep, Continuous wave generation

    MIL-1553 Harness Test Station

  • 1553B Bus Multiplexing unit
  • Sixteen Maximum Bus Stub Inputs
  • One Multiplexed Bus Stub Output
  • One Bus Monitoring Output on BNC
  • Selection of Input Bus Stubs under Software Control
  • RS232C interface to a Host PC for control
  • Expansion to a Maximum of 32 stubs using sepaRate Expansion Unit
  • Works as Standalone unit with External +5VDC Power from and AC Adapter